Sculptured docs

Open models with OpenCode

Run agents on open models such as Kimi, GLM, DeepSeek or GPT OSS, through OpenCode and an OpenRouter key.

An agent can run on an open model instead of Claude or Codex. Sculptured drives OpenCode for these agents, and OpenCode reaches the model through OpenRouter, where one key covers many open models. On the board, these agents carry the OpenCode mark: code brackets around a dot.

Before you start

OpenCode must be installed on the computer that runs the agent:

curl -fsSL https://opencode.ai/install | bash

On Windows, run npm install -g opencode-ai. If it is missing when you press Start, Sculptured says so before anything starts and shows the command to paste.

Choose OpenCode for an agent

Open the agent and set Runs on to OpenCode. Then choose its model:

A team or a group can set a default OpenCode model the same way it sets Claude and Codex models.

If OpenCode does not know the model, the agent does not start and its card says so: "OpenCode could not use the model …; check its name, like openrouter/deepseek/deepseek-chat-v3.1, and the key."

What the agent can do

OpenCode agents work like Claude Code and Codex agents: they read and change files in their folder, run commands, hand work to other agents, and use Sculptured's agent tools, such as asking you a question, messaging a teammate and writing the status page. You can message, interrupt and stop them, and they pick up where they left off when you start the team again.

Costs

Runs are billed to your OpenRouter account at OpenRouter's prices. Sculptured shows each turn's cost as OpenCode estimates it, labelled OpenCode's own estimate.

Two things are shown as they are, not filled in:

If your OpenRouter credit runs out, the turn ends and the agent's card says the usage limit was reached, with OpenRouter's own words.

What is not available yet